Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 165)

Specifying input parameters
Using LCDS Print Description Language 2-57
Default EBCDIC
VOLUME CODE
parameter: points
to note
• When you run a CODE=NONE job with DUPLEX=YES and
SHIFT=YES, you must specify MARGIN in inches.
• Input data is translated according to the CODE selected on
the VOLUME command. Any character that is translated
into an ASCII X’20’ is truncated after the last significant (non-
ASCII X’20’) character in the print record.
• On the FreeFlow Print Server LCDS systems, trailing spaces
are deleted for the current code set only. In addition,
translated characters that are beyond the highest character
code in the current font are converted to blanks and
potentially removed.
VOLUME DBCODE
Specifies which double-byte character code translation table the
system will use to interpret the input data.
Syntax VOLUME DBCODE = {keyword | id }
Options
Default No default
Table 2-59. VOLUME DBCODE parameter options and definitions
Option Definition
keyword Specifies a specific, standard, system defined double-byte code translation
table. The available options are:
•
IBM: IBM Nihongo character set (Kanji double-byte character sets)
• IBMCHN: IBM 5550 code translation table
• JEF: Fujitsu JEF Kanji double-byte character set
• KEIS: Hitachi KEIS Kanji double-byte character set
• USER: Refers to the single unlabeled DBCODE command defined within
the JDL or JDE.
id Specifies an identifier label that was used in a previously defined DBCODE
command to refer to a specific, user-defined code translation table. The id label
is required when multiple DBCODE commands are contained within the JDL.