Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 229)

Using logical processing
Using LCDS Print Description Language 3-49
RRESUME and RSUSPEND commands
The print suppression logical processing function permits you to
delete from printing groups of records that are distinguishable at
the start and end, but whose intermediate records may not be
unique or distinguishable.
Print suppression and resumption are invoked by the use of two
separate commands: RSUSPEND and RRESUME. The tests for
each command are independent and must be described
separately. Each of the commands can specify the full range of
tests as described previously for the other logical processing
commands.
When specifying either the RSUSPEND or RRESUME
command, you can also specify whether suspension or
resumption of printing occurs on the current or next record. This
is controlled by the BEGIN parameter. This additional control
provides the necessary flexibility to cope with the variability of
requirements for print suppression. The BEGIN parameter can
be specified independently in both the RSUSPEND and the
RRESUME commands.
RSUSPEND and RRESUME command parameters
The following table summarizes the parameters for the
RSUSPEND and the RRESUME commands.
The following sections describe the syntax of the RSUSPEND
and RRESUME command parameters and explain their options.
RSUSPEND and RRESUME BEGIN
Specifies whether printing will be suspended starting with the
current record or with the following one.
Syntax RSUSPEND BEGIN = {CURRENT | NEXT}
RRESUME BEGIN = {CURRENT | NEXT}
Table 3-36. Summary of RSUSPEND and RRESUME command parameters
Parameter Specifies Online Offline DJDE
BEGIN Indicates with which record the print suspension
(RSUSPEND) or resumption (RRESUME) begins. Y Y N
TEST Defines a test expression for the records at which to
suspend and resume printing. Y Y N