Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 251)

Specifying print format parameters
Using LCDS Print Description Language 4-11
Default Built from the JDL name by adding “.JDL” to the name.
ACCT DEPT
parameter: point
to note
The department name (sc) is printed on the accounting sheet,
and is entered into the accounting log for the report.
ACCT USER
Specifies the delivery destination of the one-page accounting
summary for each report. This page is always printed in the
same mode (duplex or simplex) as the report.
Syntax ACCT USER = {BIN | TRAY | BOTH | NONE}
Options
Default BIN
ACCT command: points to note
• If the report completion code on the accounting page is other
than Completed, an accounting page is delivered to the tray,
even if USER=NONE is coded. This is done to notify you of a
possible report integrity problem.
• Accounting information is accumulated at processing time,
not during printing. If the report does not complete
successfully, use the Customer Accounting feature to obtain
printing status.
ACCT command example
ACCT USER=BOTH, DEPT=’MARKETING’;
The command example above specifies that after each report is
printed, an accounting page is delivered to both the output bin
and sample tray.
Table 4-13. ACCT USER parameter options and definitions
Option Definition
BIN Directs an accounting page to the output bin.
TRAY Directs an accounting page to the sample tray.
BOTH Directs an accounting page to the output bin and the sample tray.
NONE Specifies that no accounting page is delivered.