Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 413)

Using Dynamic Job Descriptor Entries (DJDEs)
Using LCDS Print Description Language 5-59
OTEXT DJDE: point to note
The DJDE parameters are the same as for the MESSAGE
OTEXT command.
OVERPRINT DJDE
Specifies how overprint lines are handled. (Overprint lines are
print lines whose carriage control specifies printing with no line
spacing because the last printed line.)
Type Record oriented
Syntax OVERPRINT = (overopt, disp)
Options
Table 5-48. OVERPRINT DJDE options and definitions
Option Definition
overopt overprint option.
This option has the following choices:
•
PRINT: Specifies that all overprint lines are printed as they would be on an
impact printer; that is, the second line is printed over the top of the first with
no regard to the previous data, including character spacing, which may
vary between the two lines of data.
• IGNORE: All overprint lines are ignored.
• MERGE: Same as PRINT except when used with FONTINDEX or CME
processing.
Refer to “OVERPRINT DJDE: points to note” below.
• PRINT2: Specifies that up to two consecutive lines are printed per line—
one line and one overprint. Other overprints for the line are ignored.
disp (Obsolete)
This option has the following components:
•
DISP
• NODISP
NOTE: This option is not functional on DP 2000 Series EPS. It is preserved
here for compatibility with other Xerox laser printing systems. The number of
overprint lines is always printed on the accounting page.