Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 234)

Using logical processing
3-54 Using LCDS Print Description Language
In this mode, you can use the PRINT parameter to print the
delimiter (or the delimiter packet) and to select the output
destination of this delimiter page: BIN, TRAY, or BOTH. The
option BOTH delivers the page to the sample tray and to the
output tray.
The delimiter page, when printed, is output as part of the
subsequent report. All of the printing parameters selected in the
JDL remain in effect during report delimiter printing except
CARRIAGE CONTROL, which is ignored; the carriage control is
replaced by a Print and Space 1 line control.
If DJDE records exist within the delimiter packet or immediately
following, they are included on the delimiter page.
Nondelimiter
mode
If DELIMITER=NO is coded (Nondelimiter mode), a single record
separates one report from the next. After satisfying the TEST
criteria, this record is considered part of the subsequent report.
In this mode, the PRINT parameter is not available. Therefore,
the delimiter is not printed on a special page.
Delimiter on accounting page
You may include part of the first record of a report on the
accounting page. This command is selected by coding the
ACCTINFO parameter, which is normally used to print part of the
first (or only) RSTACK record.
The ACCTINFO field is captured from the first record of the
report, even if that record does not satisfy the RSTACK test.
Thus, the ACCTINFO data is captured even for a report
(boundary) that was not detected by an RSTACK test.
Status display
You can display a subfield of the first record in a report when you
display job status on the user interface screen. You select this
command by coding the HRPTNA or HJOBNO parameter.
Note that HJOBNO is not an RSTACK parameter and must be
coded in the BANNER command.