Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 303)

Specifying print format parameters
Using LCDS Print Description Language 4-63
OUTPUT LOGO
Allows you to specify a logo for imaging on all pages of a report,
unless it is canceled by a CANCEL DJDE. Up to 128 logos can
be specified on a page.
Syntax OUTPUT LOGO = (name, vpos units, hpos units [, INKS,
inkindex
1
[, inkindex
2
])])
Options
Default No default
Table 4-62. OUTPUT LOGO parameter options and definitions
Option Definition
name Name of the logo file
vpos vertical position
A value constant that specifies as an offset the vertical position of the top edge
of the logo relative to the 0,0 position on the current physical page (the position
that would be specified by a PDE BEGIN parameter value of 0,0).
hpos horizontal position
A value constant that specifies as an offset the horizontal position of the left
edge of the logo relative to the 0,0 position on the current physical page.
units The unit of measurement for the vertical and horizontal positions offset value.
Options are:
•
DOTS
• XDOTS (600 dpi dots)
• CM (centimeters)
• IN (inches)
The default unit is IN.
INKS Indicates that the ink that follows will override the inks that are defined in the
logo.
inkindex Overrides the corresponding inks that are specified in the ink list of the logo.
NOTE: For this option to be valid, the logo that is referenced must be in color
format.