Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 255)

Specifying print format parameters
Using LCDS Print Description Language 4-15
Default No default
CME FONT
parameter: points
to note
• A font specification applies to input variable data as well as to
static CME data. If a line number (LINE) and character
position (POSITION) but no insertion text (CONSTANT) are
specified, the font change that is called out applies to input
variable data at the specified position.
• Fonts may be specified at any point. The last font that is
specified remains in effect until another font is specified. An
example of a CME with these characteristics is shown below.
• Whether a font switch is applied to a CME string constant
depends upon the order in which FONT and CONSTANT are
specified in the CME. If FONT is specified before
CONSTANT, the font switch applies to the string constant. If
FONT is specified after CONSTANT, the font switch occurs
at the line position immediately after the string constant.
CME INK
Specifies the highlight color ink that will be used to print variable
data that is affected by the CME or CME constant data.
Syntax [ac:] CME INK = inkindex
Option
Default 0
XYZ: CME LINE = (1,10), POS=40, FONT=2, POS=80,
FONT=3, LINE = (11,20), POS=1, FONT=3,
POS=40, FONT=1, POS=80, FONT=2,
LINE = (31,50), POS=1, FONT=2, POS=40,
FONT=3, POS=80, FONT=1;
Table 4-17. CME INK parameter option and definition
Option Definition
inkindex An integer value that represents the ink name that will be used to print
variable data that is affected by the CME. The value must be from 1 to n,
where n is the number of inks in the current ink list (defined by the ILIST
parameter of the IDR command or by the ILIST DJDE).