Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 265)

Specifying print format parameters
Using LCDS Print Description Language 4-25
Options
Default LARGE[ST]
LINE BASELINE
parameter: point
to note
If KANJI is specified as one of the fonts (KANJI = YES), a
BASELINE=LARGE command is treated as BASELINE=TOP.
LINE BLANKTYPE
Specifies whether or not the “shift in” and “shift out” function
codes are printed as spaces.
Syntax LINE BLANKTYPE = {F | V | SPACE | NOSPACE}
Options
Default NOSPACE
Table 4-25. LINE BASELINE parameter options and definitions
Option Definition
TOP Determines the baseline position from the top of each line by using the
BASELINE parameter of the first font in the PDE font list.
CENTER Positions all of the characters so that their center lines match.
BOTTOM Determines the baseline from the bottom of each line by using the
BASELINE parameter of the first font in the PDE font list.
LARGE[ST] Determines the baseline position and the line spacing by using the largest
font in the PDE font list.
Table 4-26. LINE BLANKTYPE parameter options and definitions
Option Definition
F Specifies the width of the back space character that is associated with the
width of the full-sized single-byte character, or of the half-sized double-byte
character.
V Specifies the width of the back space character that is associated with the full-
sized single-byte or double-byte character.
SPACE Replaces X’0E’ and X’0F’ (“shift-in” and “shift-out”) function codes with single-
byte blank character spaces.
NOSPACE Specifies that no space code is substituted.