Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 154)

Specifying input parameters
2-46 Using LCDS Print Description Language
Default No default
SEFFNT SEFMAP
parameter: points
to note
• When specified without a label preceding the SEFFNT
command, SEFMAP puts all font mapping definitions within
the JDL, rather than creating a separate mapping file.
• When SEFMAP is coded outside of a standard JSL (either
prior to a JDL command or after an END command), the
system creates a file named label.LIB on the disk. This file
contains the font mappings for reference within the JSL by
other JSLs or through a DJDE.
NOTE: The .LIB file that is created by a labeled SEFFNT
command cannot be imported to, or exported from, the
FreeFlow Print Server LCDS systems. You must compile the
JSL that contains the labeled SEFFNT command, which
causes the system to recreate the .LIB file.
• When coded at the catalog level of a JSL, SEF mapping
applies to all JOBS or JDEs that include the catalog. When
coded at the job level, SEF mapping specifically assigns a
mapping to be used with this JOB or JDE.
• In the parameter (font
1
, font
2
) (font
2
,font
3
), the fact that font
1
is mapped to font
2
and font
2
is mapped to font
3
does not
imply that font
1
is mapped to font
3
.
SEFFNT MAP
References a previously defined font mapping file (filename) or a
labeled SEFFNT command defined in the current JSL file.
Syntax SEFFNT MAP = {filename | label}
REP REPLACE
Indicates that the specified font pairs create a new mapping table to replace
the current one.
Table 2-49. SEFFNT SEFMAP parameter options and definitions (Continued)
Option Definition