Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 332)

Specifying print format parameters
4-92 Using LCDS Print Description Language
Example 3 The commands in the following figure illustrate use of the
offsetting features of the OUTPUT command. The parameter
ALL offsets all copies of all reports; FIRST offsets just the first
copy of each report and NONE inhibits offsetting.
Figure 4-5. Illustration of ways to use OUTPUT OFFSET
parameter
Example 4
or
If there are ten pages in the report, either of the above
commands would cause FORM1 to be applied to pages 1, 4, 7,
and 10; no forms to be applied to pages 2, 5, and 8; and FORM3
to be applied to pages 3, 6, and 9.
Example 5 The commands in the following figure illustrate the use of
CYCLEFORMS with multiple copies. Note that every copy of a
particular page has the same form, whether COLLATE=YES or
NO. The pages in the following example are not logical pages
but are one side of a physical sheet of paper.
OUTPUT CYCLEFORMS=(FORM1, NONE, FORM3);
OUTPUT CYCLEFORMS=(FORM1,,FORM3);