Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 290)

Specifying print format parameters
4-50 Using LCDS Print Description Language
OUTPUT COVER
Specifies that cover sheets are to be fed from the AUX stock.
These cover sheets may be placed at the front or back of each
copy of a report.
Syntax OUTPUT COVER = {(FRONT [, SEP]) | BACK | (BOTH [, SEP]) |
NONE}
Options
Default NONE
OUTPUT COVER
parameter: point
to note
If RTEXT is specified along with (FRONT, SEP) or (BOTH, SEP),
RTEXT pages are printed on the covers, and front covers are
picked only on copies for which there is RTEXT. Refer to the
“ROUTE RTEXT” parameter section later in this chapter for
further details on RTEXT.
Refer to “Restrictions on job parameter modification” in the
“Using Dynamic Job Descriptor Entries (DJDEs)” chapter for
more information on COVER specified in a selected JDE.
OUTPUT CYCLEFORMS
Specifies a set of forms to be printed on report pages in a
repeating sequence.
Syntax OUTPUT CYCLEFORMS = {NONE | formid | (formid
1
[, (INKS,
inkref
1
[inkref
2
]] [, ...])] [, formid
2
[, (INKS, inkref
1
[inkref
2
] [, ...])])}
Table 4-47. OUTPUT COVER parameter options and definitions
Option Definition
NONE Specifies that no cover sheets are to be fed.
FRONT Specifies that a cover sheet will be fed as the first page of each report copy.
SEP Specifies that no data will be printed on any front cover sheet.
BACK Specifies that a cover page will be fed at the end of each copy. No report data
is printed on back covers.
BOTH Specifies that both front and back cover pages will be fed for each report copy.
The front cover sheet will be the first page of each copy.