Modifying system stp parameters, Configuring global ip routing settings, Ip r – ADC AVIDIA SWD4573I1 User Manual
Page 528: Onfiguring, Lobal, Outing, Ettings
Configuring Global IP Routing Settings
502
Avidia System Configuration and Management User Manual
Modifying System STP Parameters
In the
System Bridging Configuration
window:
1
In the
Priority
box, type the priority of the system (the entire chassis) within the network.
The valid range is 0 to 65535. The value 0 indicates the highest priority. The default value
is 32768.
2
In the
Max Age
box, type the number of seconds after which entries in the Bridging Table
will be deleted if they are not re-learned. The valid range is 6 to 40. The default value is 20.
3
In the
Hello Time
box, type the interval, in seconds, at which you want the system to send
Spanning Tree Protocol packets. The valid range is 1 to 10. The default value is 2.
4
In the
Forward Delay
box, type the number of seconds you want the system to wait before
changing the state of a particular interface (e.g., to blocked). The valid range is 4 to 30. The
default value is 15.
This delay prevents the interface states from changing so rapidly that the STP cannot keep
up with the current topology of the network and cannot therefore manage bridging
efficiently.
5
Do one of the following:
•
To activate the settings and close the
System Bridging Configuration
window, click
Set
.
•
To cancel the settings and close the
System Bridging Configuration
window, click
Close
.
C
ONFIGURING
G
LOBAL
IP R
OUTING
S
ETTINGS
You configure global settings to enable IP routing and specify the time-to-live value for IP
datagrams.
You configure global IP routing settings from the
System Settings
window. Do one of the
following to open the
System Settings
window.
•
In the
Site Map Navigation
window, click
System Settings
.
•
In the
Tree Navigation
window, click
Configuration Management
,
System Setup
,
System
Settings
.