Configuring management card ip addresses, Ip a, Onfiguring – ADC AVIDIA SWD4573I1 User Manual
Page 407: Anagement, Ddresses
Chapter 19: Configuring
System
Parameters
Avidia System Configuration and Management User Manual
381
C
ONFIGURING
M
ANAGEMENT
C
ARD
IP A
DDRESSES
You set the management card IP address, subnet mask and default gateway (if one exists) to
enable communication with external networks. While you must initially set the IP addresses
using the command-line interface, you can change this information using the Web interface. All
IP addresses use the format xxx.xxx.xxx.xxx.
1
In the
System Settings
window, click
Set IPs
.
The
Set IP Address
window displays.
2
In the
AMC Card Ethernet Port IP Address
box, type the IP address of the management card
Ethernet port.
The default management card IP address is 192.168.0.1.
3
In the
AMC Card Ethernet Port IP Subnet Mask
box, type the IP subnet mask of the management
card Ethernet port.
4
In the
AMC Card Ethernet Port IP Default Gateway
box, type the management card default
gateway (router) IP address, if one exists.
A gateway is a router on the network through which the Avidia system can communicate
with external networks. The default gateway default IP address is 192.168.0.100.
5
To activate the new default gateway IP address, click
Set,
otherwise click
Close
.
You cannot use IP addresses 192.168.1.0 through 192.168.21.255 with subnet
mask 255.255.255.0, as these addresses are restricted for internal Avidia
system use.