Adding adsl cell channel card pvpcs – ADC AVIDIA SWD4573I1 User Manual
Page 190
Configuring PVPCs
164
Avidia System Configuration and Management User Manual
Adding ADSL Cell Channel Card PVPCs
From the
::pvpc=>
prompt, do one of the following:
•
To add one PVPC, type the new command in the following format then press
. The
PVPC table index number is automatically assigned.
new
[-admin (up|down)][-txtraf
[-backup [
•
To add multiple PVPCs with the same traffic profile, type the range command in the
following format then press
. The PVPC table index numbers are automatically
assigned. At the confirmation message, type
to create the PVPCs or type
to cancel the
command.
range <#pvcs>
[-admin (up|down)][-txtraf
[-y]
Parameters
<#pvcs>
The number of PVPCs you want to create with the same traffic profile. See the table on
to verify that the ports you plan to use for the PVPCs support the number of PVPCs
you intend to create.
One of the PVPC ports (format slot.port). This can be either the line card or the channel
card port.
The other PVPC port (format slot.port). This can be either the line card or the channel card
port.
The VPI associated with the preceding
parameter in the command line. See the
for a summary of the supported VPI ranges for each card.
[-admin (up|down)]
(Optional) Type
-admin
up
to activate the PVPC. Type
-admin down
to deactivate
the PVPC. If you omit this parameter, the default admin status
up
is assigned.
ENTER
ENTER
Y
N