Displaying spvc details – ADC AVIDIA SWD4573I1 User Manual
Page 219
Chapter 8: Configuring ATM Virtual Circuits
Avidia System Configuration and Management User Manual
193
Displaying SPVC Details
From the appropriate
::spvc=>
prompt, type the detailshow command in the following
format, then press
.
detailshow
Parameters
The slot and port for which you want to display SPVC information (format slot.port).
Omitting this parameter displays all configured SPVC information for the system.
The specific VPI for which you want to display all configured SPVC information. Omitting
this parameter displays SPVC information for all VPIs.
The specific VCI for which you want to display all configured SPVC information. Omitting
this parameter displays SPVC information for all VCIs.
Example
::spvc=>detailshow 3.2 100 100
A screen similar to the following displays:
ENTER
::spvc=>detailshow
Admin Status:
Up
Operation Status:
In Progress
Source Slot:
3.2
Source VPI
100
Source VCI
100
Destination Address:
39:26:34:34:75:85:11:08
Source Tx Traffic Index:0
Source Rx Traffic Index:0
Last release cause:
0
Retry Failures:
0
Retry Interval:
10
Retry Limit:
0