ADC AVIDIA SWD4573I1 - Manual (Page 255)

Chapter 10: Configuring Bridging and Routing
Avidia System Configuration and Management User Manual 229
The DLCI (Data Link Connection Identifier) of the frame relay circuit you want to use for
this session.
<(llc-snap|vcmuxbr|vcmuxrt)>
The encapsulation mode you want to use for this PVC. The type of service specified for the
-service parameter determines the appropriate encapsulation modes. In addition, the
configured encapsulation mode must match the encapsulation mode used by the adjacent
segments in the network.
[-subs ]
A name that identifies the session. This is a text string that can be up to 32 characters in
length and can contain any character.
[-service (bridge|{{route|broute} -ipaddr -mask
})]
bridge
Configures the session for bridging only.
route
Configures the session for routing only.
broute
Configures the session for both bridging and routing.
-ipaddr
The IP address assigned to the session (format xxx.xxx.xxx.xxx). Include this parameter
only if you specified
route or broute for the service type.
-mask
The subnet mask assigned to the session (format xxx.xxx.xxx.xxx). Include this
parameter only if you specified
route or broute for the service type.
If you specified service type: Set the encapsulation mode to:
broute llc-snap
route llc-snap or vcmuxrt
bridge for SDSL—vcmuxbr
for all other cards—vcmuxbr or
llc-snap