ADC AVIDIA SWD4573I1 - Manual (Page 232)

Configuring Frame Relay Links
206 Avidia System Configuration and Management User Manual
C
ONFIGURING
F
RAME
R
ELAY
L
INKS
You configure frame relay link parameters from the ::link=> prompt. From the ::root=>
prompt, type the following command then press to display the ::link=> prompt.
configuration frame-relay link
Adding a Frame Relay Link
From the ::link=> prompt, type the new command in the following format then press
.
new [-lmitype (LMI|ANNEXA|ANNEXD|NONE)]
[-pollinterval ] [-enqinterval ] [-errthreshold ]
[-monevents ]
Parameters
The channel card slot and port (format slot.port).
[-lmitype (LMI|ANNEXA|ANNEXD|NONE)]
The LMI (Local Management Interface) type defines a method of exchanging status
information between the customer device and the network. The options are:
LMI —LMI Rev-1
ANNEXA —ITU 0.933 Annex-A
ANNEXD —ANSI T1 617 Annex-D
NONE —no LMI support
[-pollinterval ]
The poll interval value in seconds. Poll Interval is the number of seconds between LMI
status inquiry messages. The valid range is 5 to 30, with 15 as the default.
If the LMI type is set to NONE, the poll interval, inquiry interval, error threshold,
and monitor events parameters are not used.
ENTER
ENTER