ADC AVIDIA SWD4573I1 User Manual
Page 515
Chapter 24: Configuring Bridging and Routing
Avidia System Configuration and Management User Manual
489
7
In the
Encap
box, select the type of encapsulation you want to use for this session PVC
(
LLC_SNAP
,
VC_MUX_Routed
or
VC_MUX_Bridged
).
The type of service you specify in
determines the appropriate encapsulation modes.
In addition, the encapsulation mode must match the encapsulation mode used by the
adjacent segments in the network. The encapsulation mode is automatically set to
VC_MUX_Bridged
for PVCs that use SDSL cards, and cannot be modified. Use the following
table to determine the encapsulation mode.
8
In the
Service Type
box, select the
Bridging
or the
Routing
checkbox, or both, to specify the
type of service(s) for this session.
9
If you selected
Bridging
, do the following:
a
In the
STP Priority
box, type a number to indicate the Spanning Tree Protocol priority
for the session. The default range is from 0 to 255, with 0 being the highest priority.
The default value is 128.
b
In the
STP Path Cost
box, type a number to indicate the efficiency of the session. The
valid range is from 1 to 65535. The value 1 is the lowest cost, reflecting the greatest
efficiency. The default value is 250 for WAN ports and 100 for LAN ports.
If you specified service type:
Set the encapsulation mode to:
broute
llc-snap
route
llc-snap or vcmuxrt
bridge
vcmuxbr or llc-snap