ADC AVIDIA SWD4573I1 - Manual (Page 189)

Chapter 8: Configuring ATM Virtual Circuits
Avidia System Configuration and Management User Manual 163
The following table describes the information displayed after you type the atm show command:
Configuring Cell Channel Card PVPCs
You can configure cross-connect PVPCs between ATM ports on cell-based channel cards and
ATM ports on line cards. You configure PVPCs from the
::pvpc=> prompt. From the
::root=> prompt, type the following command then press to display the ::pvpc=>
prompt.
configuration atm cell pvpc
Information Description
Slot The slot number of the ATM port for which the
information is displayed.
MaxPVPCs The maximum number of PVPCs that can be
configured on the selected port.
MaxPVCCs The maximum number of PVCCs that can be
configured on the selected port.
PVPCs The current number of PVPCs configured on the
selected port.
PVCCs The current number of PVCCs configured on the
selected port.
MaxVPIBits The number of VPI bits in each cell header that
are used by the Avidia system.
MaxVCIBits The number of VCI bits in each cell header that
are used by the Avidia system.
ENTER