ADC AVIDIA SWD4573I1 - Manual (Page 169)

Chapter 7: Configuring Network Services
Avidia System Configuration and Management User Manual 143
Displaying the Configured OC3 Interface Type
From the ::optics=> prompt, type show then press . A screen similar to the
following displays.
C
ONFIGURING
DS1 S
ERVICE
This section contains instructions for configuring service for DS1 line cards installed in either
an Avidia 8000 or an Avidia 3000. To configure a DS1 line/management combination card
installed in an Avidia 2200, you must first subtend the Avidia 2200 to an Avidia 8000 or an
Avidia 3000 using the command-line interface (See
“Subtending Multiple Systems” on page 45
and “Setting Up Connections” on page 70 for more information). Then, use in-band
management or the command-line interface to configure DS1 service on the DS1
line/management card.
You configure DS1/T1 channels from the ::ds1=> prompt. From the ::root=> prompt,
type the following command then press to display the ::ds1=> prompt.
configuration ds1
ENTER
::optics=> show
***** THE OC3 CONFIGURATION TABLE FOR PORT 2.1 *****
Loopback Configuration: None
Cell Scrambling : Enabled
***** THE OC3 CONFIGURATION TABLE FOR PORT 2.2 *****
Loopback Configuration: None
Cell Scrambling : Enabled
ENTER