ADC AVIDIA SWD4573I1 - Manual (Page 175)

Chapter 7: Configuring Network Services
Avidia System Configuration and Management User Manual 149
C
ONFIGURING
DS3 S
ERVICE
You configure DS3 service from the ::ds3=> prompt. From the ::root=> prompt, type the
following command then press to display the ::ds3=> prompt.
configuration ds3
Configuring DS3 Ports
From the ::ds3=> prompt, type the set command in the following format then press .
set [-clock (loop|local)] [-lbo index] [-type (m23|cbit)]
[-mode (direct|plcp)] [-loopback (none|local|line|remote)]
[-scrambling (enable|disable)]
Parameters
The channel slot and port number (format slot.port).
[-clock (loop|local)]
The type of clocking, either loop or local timing. Type -clock loop or -clock
local .
[-lbo index]
The line build out, in feet. Determine the value for , based on the length of the
line, as follows:
[-type (m23|cbit)]
The type of DS3 line. Type -type m23 or -type cbit . The cbit line type is not
currently supported.
Index Line Build Out
0 0 to 225 feet (68.5 meters)
1 More than 225 feet
ENTER
ENTER