Initiating ds3 loopbacks – ADC AVIDIA SWD4573I1 User Manual
Page 373
Chapter 17: System Maintenance and Administration
Avidia System Configuration and Management User Manual
347
Parameters
[-loopback (none|local|line|payload|remote)]
The type of loopback to start. See the table on
for information. Type
none
to
cancel the loopback.
Examples
::ds1=> 2.1 -loopback payload
::ds1=> 2.1 -loopback none
Initiating DS3 Loopbacks
Configure DS3 service from the
::ds3=>
prompt. From the
::root=>
prompt, type the
following command then press
to display the
::ds3=>
prompt.
configuration ds3
From the
::ds3=>
prompt, type the set command in the following format then press
.
set
Parameters
[-loopback (none|local|line|remote)]
The type of loopback to start. See the table on
for information. Type
none
to
cancel the loopback.
Examples
::ds3=> set 12.1 -loopback local
::ds3=> set 12.1 -loopback none
The set command is also used to configure DS3 ports. See
for information about DS3 port configuration
parameters.
ENTER
ENTER