Spectra Precision Survey Pro v4.9 - Manual (Page 44)

Edit Point - Geodetic Location
[Job] [Edit Geodetic] [Edit…] [Geodetic]
The Geodetic card is used to modify the geodetic parameters.
Has Geodetic Data: check this option if the point has geodetic data. You can then enter a Latitude, Longitude, and
Height.
[Advanced]: tap to open the Edit GPS Point Flags screen. This allows you set up a group and select GPS Control
Points.
Edit Polylines
[Job] [Edit Polylines]
The Edit Polylines screen is used to add, edit, and delete polylines in the current job.
The first screen will display a list of all the polylines that are stored in the current job. Selecting any of the polylines
listed will display a horizontal (overhead) and vertical (side) view of that polyline.
[Edit…]: Open the selected polyline in the New Polyline screen, described below.
[Delete…]: Delete the selected polyline.
[New…]: Open the Polyline Editor where a new polyline can be created.
Import PL5: Import polylines. Available on the Power menu button item. Tap the down arrow to open this menu from
the Edit Polylines screen.
Export PL5: Export polylines. Available on the Power menu button item. Tap the down arrow to open this menu from
the Edit Polylines screen.
New Polyline
The second screen is used to define all of the points that are used in the polyline. Any curve information will be
entered later, but the end points must still be selected at this point.
The current polyline is shown on color displays with bold red lines and all other polylines are shown using thin black
lines. Only the current polyline data can be edited.
[Tap Points…]: Opens a map view where the points in your polyline can be tapped. They must be tapped in the order
that they occur in the polyline.
[To/From…]: Allows you to define a range of points to define a polyline.
[Edit…]: Opens the third screen, described next, where the current polyline can be modified.
[Clear]: Removes the current polyline.
44