Spectra Precision Survey Pro v4.9 - Manual (Page 220)

[Tap Road…]: opens the Tap on a Road screen where you can tap on any road in the job to select it.
Name: displays the name of the selected road.
Begin Station: displays the station assigned to the beginning of the road.
End Station: displays the final station in the road.
[Backsight…]: Opens the Station Setup screen..
[Next >]: takes you to the next Stake Road screen where a specific point on the road can be selected to stake.
Stake Road - Screen 2
The second Stake Road screen displays a cross-sectional profile view of the road at the current station. Any particular
point on this view can be selected and staked.
Station Interval: is the value that is added to the Station to Stake after the [Next Station] button is pressed.
[Next Station]: advances the Station to Stake by the Station Interval.
Note: If the Stake Corners option is selected in the Stakeout Settings screen, the [Next Station] button will also stop at
any horizontal or vertical alignment node, and the beginning and end of any widening and super elevation that falls
within the interval.
, : These buttons are used to select the particular node, or an offset to it, from your road profile that you wish
to stake. The segment name at the selected node is also displayed. If staking the centerline with an offset, the side of
the road that the offset occurs is also displayed.
Offset: When checked, allows you to specify an offset distance to stake as opposed to staking the actual node
locations.
Note: A positive value offset is applied at the specified distance from each node away from the centerline. A negative
value offset is applied at the specified distance from each node toward the centerline.
Note: If an offset occurs past the edge of the road, no vertical or cut / fill information will be computed for that point.
Subgrade: When checked, allows you to specify a vertical offset from the actual node locations. Positive values result
in the stake location occurring below the selected node. Negative values result in the stake location occurring above
the selected node.
[Backsight…]: Opens the Station Setup screen..
[< Back]: returns to the previous screen.
[Next >]: takes you to the next Stake Road screen where the direction and distance information to the stake point is
displayed.
Stake Road - Screen 3
220