Start static occupy (static), Receiver session, Screen – Spectra Precision Survey Pro v4.9 User Manual
Page 131: Start static, Connect to post process, Post processing start, Static receiver session

Recoverable Files tab: Lists the details of all the files on the receiver that were recently deleted. Files can be selected
from this list and recovered.
Recover Selected File(s): Restores the selected files on the receiver.
Start Static
[Survey] [Start Static]
When you are starting a static post processing survey you will first be prompted to select a receiver with the
screen.
Connect to Post Process
The Connect to Post Process screen is used to select a receiver capable of post process data logging. The function and
interface of the list of receivers is described in the
[Connect >]: Connects to the selected receiver and checks the post processing session status for that receiver. If the
receiver is not currently logging data, the
screen opens. If the receiver is currently logging data,
the
prompt will appear.
Post Processing Start
The Post Processing Start screen is used to select the recording interval and begin logging on the receiver.
Recording Interval: Select the recording interval for post processing data collection.
Start Static: Start a post processing log file in Static mode, where the receiver will remain over a single point for the
duration of the session. Once the file is begun, the
screen opens.
Start Stop/Go: Start a post processing log file in Stop and Go mode, where the receiver will move between points,
and stay stationary on points of interest for periods of time during the survey. Once the file is begun, the
screen opens.
Note: The location of the file is usually on the receiver’s built in memory. However, some models support collection
of post processing data to a file on the data collector. For those receivers that support it, the location of the log file is
specified on the
Note: The Post Processing screen is used to start a post processing only survey. If you wish to record post processing
data simultaneous with RTK, then you should set the recording interval on the Set Base Receiver screen and/or the Set
Rover Receiver screen when starting a RTK survey
Static Receiver Session
[Survey] [Post Processing] [Start ... >]
or [Survey] [Occupy]
The Static Receiver Session is used to enter the station name and antenna height for a static post processing
occupation. This screen opens up after you have started a static session with the Post Processing Start screen, or if you
tap [Survey] [Occupy] and you are connected to a receiver that is already logging static data.
Store point in: Select how to store this session. You will always get a session recorded in the post processing log file.
Select Receiver and job file to also store a point record in the the software .JOB file as well. By default, post
131