Watlow LogicPro - Manual (Page 82)

Chapter 6: Variables LogicPro User’s Guide
66 Watlow Anafaze Doc.# 28002-00 Rev 3.00
Replace All
Selecting Replace All replaces all the existing Resource or
Program Variables with corresponding Variables in the
import file, with the following qualifications:
• If a new Variable name from the ASCII file is identical
to an existing Variable in your Resource or Program
Variables, the existing Variable is replaced by the new
one.
• If a new Variable name from the ASCII file is not
identical to any existing Resource or Program Variable
name, a
Verify dialog box opens informing you that the
specific Variable does not exist. The dialog then prompts
you to Append the Variable.
• If a Variable exists in your Resource or Program and no
duplicate named Variable exists in the import file, it is
unaffected and still exists after the import operation is
complete.
Replace I/O Variables Only
Replace I/O Variables only results in a similar effect to the
Replace All option except that only the I/O Variables are
affected as described above. Any other Variables are not
affected in any way.
If you select... Then...
Yes
The new Variable data in the ASCII file
replaces the Variable data presently in
the Resource or Program file.
No
The new Variable data in the ASCII file
is ignored and the existing Resource
or Program data is unchanged.
If you select... Then...
Yes
The Variable is added to your
Resource of Program Variable.
No The new Variable is ignored.