Watlow LogicPro - Manual (Page 270)

Chapter 16: Cross-Referencing LogicPro User’s Guide
254 Watlow Anafaze Doc.# 28002-00 Rev 3.00
Report Setup
In the Report Setup dialog box, as shown in Figure 16.3 on
page 254, you can select:
• What Variable information is printed in the cross-
reference Variable codes, by using
Variables Setup .
• Ladder documentation, by selecting Ladder .
• Specific information included in the Ladder
documentation output, by clicking the
Ladder Setup
button.
• SFC documentation, by selecting SFC .
• Specific information included in the SFC documentation
output, by clicking the
SFC Setup button.
• FBD documentation, by selecting FBD .
• Specific information included in the FBD documentation
output, by clicking the
FBD Setup button.
• Cross-reference for the entire Program, by selecting
Cross Reference .
• I/O Table, by selecting I/O Table .
The I/O Table is a list of all Program Variables that use I/O
Drivers, sorted by I/O Driver.
Figure 16.3 Report Setup Dialog Box