Watlow LogicPro - Manual (Page 114)

Chapter 8: Ladder Diagrams LogicPro User’s Guide
98 Watlow Anafaze Doc.# 28002-00 Rev 3.00
1. Make sure that the extension you want to add will not get
in the way of any existing element. Figure 8.22 shows a
Ladder diagram that is ready to accept an extension rail.
2. Select the new element type from the toolbar.
3. Click and hold on the right side of the left power rail.
Handles appear to indicate that you selected an existing
rail.
4. Drag just to the right of left vertical line of the branch to
which you want to attach.
5. Release the mouse button. A new extension rail is
created, as
shown in Figure 8.23, along with the new element.
Figure 8.22 Adding an Extension from the Left
Power Rail
Figure 8.23 After Adding an Extension from the
Left Power Rail
Cutting Rungs
To cut a rung:
1. Select the [Selector] tool.
2. Position the pointer to the left of the Left Power Rail
(each Rung has its own unique number)
3. Click on the number of the Rung number that you want
to Cut. You may select multiple Rungs by holding down
the left mouse button and dragging the “dotted box”
around adjacent Rung numbers.