Watlow LogicPro - Manual (Page 113)

LogicPro User’s Guide Chapter 8: Ladder Diagrams
Doc.# 28002-00 Rev 3.00 Watlow Anafaze 97
NOTE! This procedure is valid only when the selected el-
ement type is one of the three output coil types.
However, other element types may be placed be-
fore the coil in a multiple output coil branches.
Figure 8.19 Before Creating Multiple Output
Coil Branches
Figure 8.20 After Creating Multiple Output Coil
Branches
NOTE! If the top most coil in a multiple output coil
branches is deleted, a horizontal line will remain,
as shown in Figure 8.21. This should not be a
cause of concern as it is only the graphical repre-
sentation and does not mean a ‘short circuit’ in
the actual control logic.
Figure 8.21 Multiple Output Coil Branches
after the Top Coil is Removed
Inserting Elements From the Left Power Rail
To create an extension from the left power rail to existing
parallel OR branches or multiple output coil branches: