Watlow LogicPro - Manual (Page 225)

LogicPro User’s Guide Chapter 12: Function Blocks
Doc.# 28002-00 Rev 3.00 Watlow Anafaze 209
The following sections describe the address syntax used with each
category of IO Driver.
Hardware Specific Drivers
The hardware IO drivers are used to access digital I/O states and
process variable values. The specific IO value is addressed by
number. Table 12.12 lists the hardware specific drivers and the
corresponding database offset ranges.
Table 12.12 Addresses Used for Hardware
Specific Drivers
Parameter Specific Drivers
The parameter specific IO Drivers (Setpoint, Soft_Input, Soft_Bool,
and Soft_Int) are used to read or set values for specific parameters.
The specific parameter value is addressed with its database offset.
Table 12.13 lists the parameter specific drivers and the
corresponding database offset ranges.
Table 12.13 Addresses Used with Parameter
Specific IO Drivers
Database Driver
The Database IO Driver is used to examine or set values for any
closed-loop control parameter such as Control Mode that is not
supported by one of the other drivers. The Database driver allows
access to all controller parameters. Other drivers are provided for
faster access to specific parameters. Of course, controller parameters
that are read-only cannot be adjusted. The specific parameter value
is addressed with the parameter number and its database offset. See
Table 12.14 on page 210 for a description of this syntax.
IO Driver IO Physical Addresses
CPC400_PV
Channel Number (1 to 5)
CPC404, (1 to 9) CPC408
CPC400_Digital_Out Digital Output Number (1 to 34)
CPC400_Digital_In Digital Input Number (1-8)
IO Driver Database Offset
Setpoint
Channel Number (1 to 5) CPC404,
(1 to 9) CPC408
Soft_Input Soft Input Number (1-9)
Soft_Bool Soft Bool Number (1-256)
Soft_Int Soft Int Number (1-100)