Watlow LogicPro - Manual (Page 271)

LogicPro User’s Guide Chapter 16: Cross-Referencing
Doc.# 28002-00 Rev 3.00 Watlow Anafaze 255
Variables Setup
In the Variables Setup dialog box, as shown in Figure 16.4
on page 255, check the boxes corresponding to the
information to be included in the Variable Report:
• If comments about the Variable are included on the line
after the Variable code, by selecting
Comment .
• If the Initial Value for the Variable is included, by
selecting
Initial Value .
• If the I/O Address for the Variable is included, by
selecting
I/O Address .
• If the I/O Driver for the Variable is included, by selecting
I/O Driver .
• If the Size for the Variable is included, by selecting Size .
• If the Type for the Variable is included, by selecting
Type .
Figure 16.4 Variable Setup Dialog Box
Ladder Setup
In the Ladder Setup dialog box, as shown in Figure 16.5 on
page 256, you can select what information is included for each
Rung of a Ladder. For example, you can select:
• If the rung graphic is output, by selecting Graphic .
• If the rung comments are output, selecting Comments .
• If a cross-reference of the Variables in the rung are
output, by selecting
Cross Reference .