Watlow LogicPro - Manual (Page 244)

Chapter 14: Simulation LogicPro User’s Guide
228 Watlow Anafaze Doc.# 28002-00 Rev 3.00
Table 14.1 Simulation Tools
Simulation Setup
To set up timers and scan rates:
1. Select the Simulatio n menu.
2. Select Simulation Setup
– or –
Click the
[Simulation Setup] tool. This will cause the
Simulation Setup dialog box to open, as shown in
Figure 14.3 on page 229.
3. Click on the desired Timer Tick setting, the default
setting is 1.
4. Click on the desired Number of Scan setting, the
default is continuous.
5. Click [OK] .
This Button... Performs This Function...
Simulation Setup
Increment Simulation Timer Ticks
Scan Simulation Logic
Simulation Reset
Change Simulation Variables