Fairbanks X SERIES PR 5410 Process Indicator - Manual (Page 88)

Section 4: Commissioning
10/08 88 51207 Revision 1
4.7.3 SMA Protocol
Select an RS-485 interface under -[Serial ports parameter].
Setup/Serial ports
Printer - none -
Remote display Slot1 RS232
JBUS/MOD-Bus Slot2 RS485
SMA Slot1 RS485
Param
Only the baud rate is adjustable; the other parameters are fixed.
Setup/Serial ports/Slot1 RS485
Assigned to SMA
Protocol SMA
Baudrate 9600 bd Press to select [Baudrate] and
Bits 8 set the baud rate with
Parity none
Stopbits 1
The SMA protocol is described in Chapter 4.8.
4.7.4 EW Protocol
At configuration of serial ports -[Serial ports parameter] a serial port for [Asycom] has to be
selected and the protocol and communication parameters have to be set.
Setup/Serial ports
Printer - none -
Remote display Slot1 RS232
JBUS/MOD-Bus none
SMA none
Asycom Slot1 RS485
Param
Setup/Serial ports/Slot1 RS485
Assigned to Asycom
Protocol Asycom V1 Select V1, V2 or V3
Baudrate 9600 bd Select e.g. [Baudrate] with and with
Bits 8 the transfer parameter
Parity even Fixed setting
Stopbits 1 Fixed setting
Slave A Select A - Z
The PR 1612 Instructions for the EW-Protocol are described in chapter 6 .