Fairbanks X SERIES PR 5410 Process Indicator - Manual (Page 5)

Table of Contents
10/08 5 51207 Revision 1
3.5 C ONNECTING L OAD C ELLS , C ONTINUED
3.5.3 Connecting up to 8 Load Cells (650 Ohms) Using 6-Wire Connecting Cable 53
3.5.4 Connecting Load Cells with External Supply 54
3.5.5 Connecting Load Cells via Intrinsically Safe Load Cell Interface PR 1626/60 55
3.5.6 Connecting Platforms (CAP...) 56
4 Commissioning ........................................................................................................... 57
4.1 D ATA P ROTECTION /P OWER F AILURE ........................................................................................ 57
4.1.1 CAL Switch 57
4.2 S WITCHING ON THE I NSTRUMENT .............................................................................................. 58
4.2.1 Display Test 58
4.2.2 Front-Panel Key Test 58
4.2.3 Resetting the Instrument to the Factory Settings 58
4.2.4 Setting the Network Address Using Front-Panel Keys 59
4.2.5 Viewing the Network Address via Front-Panel Keys 59
4.2.6 Searching the Instrument in the Network Using 'IndicatorBrowser' 59
4.2.7 Loading New Software 60
4.3 C ONFIGURATION AND C ALIBRATION USING F RONT K EYS ........................................................... 61
4.3.1 Meaning of Front Keys 61
4.3.2 Entering Date and Time 61
4.3.3 Parameter Table 62
4.3.4 New Calibration using Front Keys 64
4.3.5 Subsequent Change of Deadload using Front Keys 65
4.3.6 View Calibration Data 65
4.3.7 View Calibration Data for Deadload and Maximum Load 66
4.3.8 PIN Code 66
4.4 O PERATION U SING A PC .......................................................................................................... 67
4.4.1 Operation Using the VNC Program 67
4.4.2 Operation Using Internet Browser 68
4.4.3 INFO Function 69
4.4.4 Setup Function (VNC) 70
4.4.5 Setup Menu (VNC): Overview 70
4.4.6 Calibration Menu 71
4.5 C ALIBRATION ........................................................................................................................... 72
4.5.1 Displaying Calibration Data 72
4.5.2 Selecting the Calibration Mode 73
4.5.3 Determining the Maximum Capacity (Max) 74
4.5.4 Determining the Scale Interval 75
4.5.5 Determining the Dead Load 75
4.5.6 Calibration with Weight (by Load) 76
4.5.7 Calibration with mV/V Value 77
4.5.8 Calibration with Load Cell Data (“Smart Calibration“) 78
4.5.9 Subsequent Dead Load Correction 79
4.5.10 Linearization 80
4.5.11 Test Value Determination / Display 80
4.5.12 Finishing / Saving the Calibration 81
4.5.13 Parameter Input 81
4.6 E RROR M ESSAGES ................................................................................................................... 85
4.6.1 Measuring Circuit Error Messages 85
4.6.2 General Error Messages 85
4.7 C ONFIGURING G ENERAL P ARAMETERS ..................................................................................... 86
4.7.1 Date and Time 86
4.7.2 Serial Ports 86
4.7.3 SMA Protocol 88
4.7.4 EW Protocol 88
4.7.5 Operating Parameters 89
4.7.6 Printing Parameters 90