Fairbanks X SERIES PR 5410 Process Indicator - Manual (Page 60)

Section 4: Commissioning
10/08 60 51207 Revision 1
4.2.7 Loading New Software
Press Setup at the instrument
DS,PTS,Tw Press to reach the BIOS menu
BIOS w Press
BIO,S..w Is displayed, followed by
FLASH w Press
ETHERw For flashing over the network, you can press
SERIALw Alternatively, you can press to select the built-in serial interface
DHC,P..w Now, the instrument indicates: Waiting for address assignment by the server
17,202,4w The most significant part of the Ethernet address is displayed
2,108,1w Subsequently the least significant part of the Ethernet address is displayed
FLASH?w
The instrument is waiting for the start of the FlashIt program.
Run FlashIt!32 Rel. 02.60.02, Nov 21 2006
Select the network
Enter the instrument IP address
Select the module to be flashed
Click [Flash] to start the procedure
In case BIOS, firmware and application must be updated, the procedure must be executed
sequentially.