Fairbanks X SERIES PR 5410 Process Indicator - Manual (Page 70)

Section 4: Commissioning
10/08 70 51207 Revision 1
4.4.4 Setup Function (VNC)
Press to configure the main operating parameters. The configuration depends on the
application licenses registered and the plug-in cards installed.
Calibration is in a simple dialogue. Compliance with the relevant (verification) standards must be
checked by the person commissioning the instrument or the verification officer. To protect the
calibration data from overwriting, close the corresponding CAL switch on the back panel of the
instrument. On legal-for trade instruments, the CAL switch must be sealed in the closed (write-
protected) position; see Chapter 4.1.1.
4.4.5 Setup Menu (VNC): Overview
- Serial ports parameter
- Printer , Builtin RS 232, Slot 1 .. 2 RS 485, Slot 1 ... 2 RS 232
- Remote display , Builtin RS 232, Slot 1 .. 2 RS 485, Slot 1 ... 2 RS 232
- JBUS/MOD-Bus , Builtin RS 232, Slot 1 .. 2 RS 485, Slot 1 ... 2 RS 232
- SMA , Builtin RS 232, Slot 1 .. 2 RS 485, Slot 1 ... 2 RS 232
- Asycom , Builtin RS 232, Slot 1 .. 2 RS 485, Slot 1 ... 2 RS 232
- Param Assigned to, Protocol, Baud rate, Bits, Parity, Stop bits,
- Date & Time Change date and time
- Operating parameter
- Address Address of the instrument
- PIN Access code for setup
- Use Alibimemory None, Gross, Net, Tare combinations
- Sequencenumber Sequence number
- SetTareKey Tare& reset tare, tare&tare again, disabled
- SetZeroKey Only when not tared, reset tare on zeroset, disabled
- N-B-T-Key enabled, disabled
- PrintKey enabled, disabled
- Printing parameter
- Print mode Print selected items, via Nice Label
- 1 ... 6 Item Select: Gross weight, net weight, tare weight, date & time,
sequence number
- Fieldbus parameter Only if PR 1721/XX is installed in Slot 4; see Chapter 4.7.7
- Network parameter Hardware address (read only), Host name, IP address, Subnet
mask, Default gateway, VNC-Client (access restriction)
- Calibration New, Modify, Param; see Chapter 4.4.6
- Limit parameter
- Limit 1/2/3 on/off Limit 1/2/3 'on'/ 'off', Action, Condition; see Chapter 4.8.5
- Digital I/O parameter
- Output 1/2/3 Configuring outputs; see Chapter 4.8.3
- Input 1/2/3 on/off 3 Inputs, Action, Condition; see Chapter 4.8.4
- BCD Gross, Net if tared, selected, transparent; see Chapter 4.8.6
- Analog output parameter Gross, Net if tared, selected, transparent; see Chapter 4.9