Fairbanks X SERIES PR 5410 Process Indicator User Manual
Page 67
Section 4: Commissioning
10/08 67
51207 Revision 1
4.4 O
PERATION
U
SING A
PC
4.4.1 Operation Using the VNC Program
VNC stands for 'virtual network computing' and is a program for remote operation of computers.
The program distinguishes between the VNC server and VNC client (viewer). The server program is
part of the instrument software. The client program (viewer) must be installed and executed on the
PC to be used for operating the instrument.
For direct operation using the VNC program, the IP
address (extended by : 1) must be specified when you
run the program; e.g. 172.24.21.85:1 .
The address range of the controlling PC
can be limited in the instrument; see
Chapter 4.7.8 .
The operator interface of the VNC
program appears: