Fairbanks X SERIES PR 5410 Process Indicator - Manual (Page 137)

Section 7: Fieldbus Interface
10/08 137 51207 Revision 1
7.3.6 Register 5: Device Type and Software Release
Only reading is permitted.
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Byte 0 TYPE MSB
Byte 1 TYPE LSB
Byte 2 MAINVERSION
Byte 3 SUBVERSION
E.g. 5410 Rel 1.23 = 54100123
hex
7.3.7 Register 6: Board Number
Only reading is permitted.
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Byte 0 Board number MSB
Byte 1 ""
Byte 2 ""
Byte 3 Board number LSB
E.g. 148388723 = 08D83B73
hex
7.3.8 Register 7: (Reserved)
7.3.9 Register 8 ...15: Weight Data
Only reading is permitted.
The gross, net and tare weight are stored as DINT fixpoint.
The real data value is derived from DINT and EXPO as follows :
Value
Real
=reading
DINT
*10 (-EXPO
Register 8 Current gross value
Register 9 Current net value, if tared; otherwise gross
Register10 Current tare value, if tared, otherwise 0
Register11 Value on the front-panel display
Register12 Reserved
Register13 Reserved
Register14 Max
Register15 Reserved
7.3.10 Register 20: Weight Data
Register 20 BCD output value
7.3.11 Register 22 ... 27: Limit Values (Read/Write)
Register 22 Limit 1 on
Register 23 Limit 1 off
Register 24 Limit 2 on
Register 25 Limit 2 off
Register 26 Limit 3 on
Register 27 Limit 3 off