Fairbanks X SERIES PR 5410 Process Indicator - Manual (Page 10)

Section 1: Warnings and Safety Precautions
10/08 10 51207 Revision 1
1 Warnings and Safety Precautions
This instrument has been built and tested in compliance with the safety
regulations for measuring and control instrumentation for protective class I
(protective earth connection) according to IEC 1010/ EN61010 or VDE 0411. The
instrument was in perfect condition with regard to safety features when it left the
factory. To maintain this condition and to ensure safe operation, the operator
must follow the instructions and observe the warnings in this manual.
1.1 I NTENDED U SE
The instrument is intended for use as an indicator for weighing functions. Product operation,
commissioning and maintenance must be performed by trained and qualified personnel who are
aware of and able to deal with the related hazards and take suitable measures for self-protection.
The instrument reflects the state of the art. The manufacturer does not accept any liability for
damage caused by other system components or due to incorrect use of the product.
1.2 I NITIAL I NSPECTION
Check the content of the consignment for completeness and inspect it visually for signs of damage
that may have occurred during transport. If there are grounds for rejection of the goods, a claim must
be filed with the carrier immediately and the sales or service organization must be notified.
1.3 B EFORE C OMMISSIONING
Visual inspection:
Before commissioning and after and storage or transport, inspect the instrument
visually for signs of mechanical damage.
1.3.1 Installation
The front panel of the instrument housing meets IP65. It is suitable for mounting in any position. To
ensure proper cooling of the instrument, make sure air circulation around the instrument is not
blocked. Avoid exposing the instrument to excessive heat; e.g., from direct sunlight. Ambient
conditions must be taken into account at all times. The instrument is suitable for control
cabinet/panel mounting.
1.3.2 Opening the Instrument
CAUTION:
DANGER OF
DEATH
Working on the instrument while it is switched on may have life-threatening
consequences.
Disconnect the instrument from the supply voltage. Any time covers or parts are
removed, live parts or terminals may be exposed.
Capacitors in the unit may still be charged also after disconnecting the unit from
all voltage sources.
This instrument contains electrostatic sensitive components. For this reason, an equipotential
bonding conductor must be connected when working on the open instrument (antistatic protection).