Fairbanks Toledo DigiTol - RC/Intalogix Conversion - Manual

Section 1: Introduction
The 'Toledo DigiTol to RC' conversion kits are designed to upgrade truck
scales with DigiTol load cells to the Fairbanks RC load cell system, by removing
DigiTol load cells and mounting hardware under Toledo scale decks and
replacing with Fairbanks' hardware and RC load cells. The kits do NOT contain
interface electronics such as Sectional Controllers or junction boxes.
Section 2: Installation
A. Tools Required:
Two Hydraulic Jacks (with safe capacity for the deck you're lifting)
Hand Tools
Welder
Precision Level(s)
High Quality Grease
Wood Blocks for Safety
B. Removal of existing parts:
1. Remove power to the system.
2. Before jacking the scale, set all existing checking so that it
touches all striker surfaces; this will keep the deck centered.
3. Place the jacks under the scale, at opposite sides, starting at 1
end and raise the deck only enough to remove the DigiTol load
cells, 2 at a time. Set wood blocks under the scale to act as
safety stands. Remove the quick disconnect plug and set the
cells aside then remove the junction box cables.
8/04 1 50651 Issue # 2
Bulletin 50651 Issue #2
Toledo DigiTol - RC/Intalogix™ Conversion
Instructional Bulletin 8/04
0