Fairbanks X SERIES PR 5410 Process Indicator - Manual (Page 107)

Section 4: Commissioning
10/08 107 51207 Revision 1
4.11.3 Establish Communication to the Instrument
In the Navigator area the folder 'Mixhouse' with the
configuration 'Charge.cfg' is present. After double click on
the [Charge.cfg] and click on [Login] with [ConfigureIt] -
[Communication Parameter] the interface to the instrument
can be set.
With [Search Device] all instruments of the selected
identical type can be found in the network. If the address
of the instrument is known, it can be directly entered in [IP-
Address].
The instruments of the selected type found in the network
are shown, the instrument to be configured can be
selected, continue with [OK].
The IP-Address of the selected instrument is taken.
With [ConfigureIt]-[Connect Device] the communication to
the instrument is started.