beautypg.com

Sample gas conditioners (options 86 & 88) – Teledyne 9110E - Nitrogen Oxides Analyzer User Manual

Page 56

background image

Optional Hardware and Software

Model 9110E Instruction Manual

42

M9110E Rev B

Figure 5-3: M9110E Ethernet Card and Rear Panel With Ethernet Installed

5.9. Sample Gas Conditioners (Options 86 & 88)

Several permeation devices using Nafion

®

permeation gas exchange tubes are available for

applications with high moisture and/or moderate levels of NH

3

in the sample gas. This type

of sample conditioner is part of the standard M9110E equipment to remove H

2

O and NH

3

from the ozone generator supply gas stream but can be purchased for the sample gas

stream as well. All gas conditioners remove water vapor to a dew point of about –20° C
(~600 ppm H

2

O) and effectively remove concentrations of ammonia up to about 1 ppm.

More information about these dryers and their performance is available at

http://www.permapure.com/.

The following options include the hardware required to install the dryers.

Table 5-4: Dryer and NH

3

Removal Options

Option Number

Description

Standard Equipment

Single gas conditioner (dryer / NH

3

removal) for ozone generator supply gas

stream only. Includes mounting bracket for two dryers (Option 86 mounts on
the back).

OPT 86

Single gas conditioner (dryer / NH

3

removal) for sample gas stream only.

Mounts on the back of the existing dryer bracket. Converts analyzer to dual-
conditioner instrument.

OPT 88

Single combination gas conditioner (dryer / NH

3

removal) for both the

sample gas and ozone supply air. Replaces the standard dryer for O

3

air and

comes with mounting bracket.

The combination conditioner is a low-cost option for drying both the sample gas and ozone
supply air with one dryer. However, this dryer can only be used in applications where both

sample and calibration gases (after dilution) are at or near ambient and constant concen-
trations of oxygen (about 20%), because the ozone generator needs a high and constant

amount of oxygen to generate ozone properly. Stack applications or industrial applications

in which the sample gas has a significantly reduced or highly variable concentration of