Teledyne 9110E - Nitrogen Oxides Analyzer - Manual (Page 49)

Model 9110E Instruction Manual Optional Hardware and Software
M9110E Rev B 35
5. OPTIONAL HARDWARE AND SOFTWARE
This section includes a descriptions of the hardware and software options available for the
Model 9110E Nitrogen Oxides Analyzer. For assistance with ordering these options please
contact the sales department of Teledyne Analytical Instruments at:
TEL: 626-961-9221
FAX: 626-961-2538
WEB SITE: http://www.teledyne-ai.com/
5.1. External Pumps (Option 10)
The M9110E comes equipped with an external pump specified upon ordering. Whereas the
analyzer can be re-configured for other voltages, operation at other than the original
voltage/frequency may require a different external pump. A variety of external pumps are
available for the M9110E series analyzers. The range of available pump options meets all
typical AC power supply standards while exhibiting the same pneumatic performance.
TAI Part No. Description
009810300 External pump for 115 VAC / 60 Hz power supply
009810400 External pump for 230 VAC / 50 Hz power supply
009810500 External pump for 110 VAC / 50 Hz power supply
009810600 External pump for 100 VAC / 50 Hz power supply
009810700 External pump for 220-240 VAC / 50-60 Hz power supply
5.2. Rack Mount Kits (Options 20-23)
There are several options for mounting the analyzer in standard 19” racks. The slides are
three-part extensions, one mounts to the rack, one mounts to the analyzer chassis and the
middle part remains on the rack slide when the analyzer is taken out. The analyzer locks
into place when fully extended and cannot be pulled out without pushing two buttons, one
on each side.
The rack mount brackets for the analyzer requires that you have a support structure in your
rack to support the weight of the analyzer. The brackets cannot carry the full weight of an
analyzer and are meant only to fix the analyzer to the front of a rack and to prevent it from
sliding out of the rack through user intervention or vibration.
Option Number Description
OPT 20A Rack mount brackets with 26 in. chassis slides.
OPT 20B Rack mount brackets with 24 in. chassis slides.
OPT 21 Rack mount brackets only
OPT 23 Rack mount for external pump (no slides).
5.3. Carrying Strap Handle (Option 29)
The chassis of the M9110EH/EM analyzer allows to attach a strap handle for carrying the
instrument (Figure 5-1). The handle is located on the right side and pulls out to