Appendix glossary introduction index contents top – Fujitsu Ricoh Fujitsu fi-7700 Document Scanner User Manual
Page 88
Chapter 4 Various Ways to Scan
88
4
Scan the document with the image scanning application.
For details, refer to the image scanning application manual.
Scanning Documents such as Envelopes or
Multi-Layered Transfer Paper
Sliding the feed mode switch to the left to switch the feed
mode to Manual/Single mode allows you to scan documents
such as envelopes and multi-layered transfer paper. Manual/
Single mode reduces the load on documents placed in the
feeder so that documents are fed without any fault for a
successful scan.
1
Load a document in the ADF paper chute (feeder).
To scan a multi-layered transfer paper, position the bound edge first
when loading the paper.
For details, refer to
"Chapter 2 How to Load Documents" (page 39)
ATTENTION
Moving the feed mode switch during a scan causes an error.
Setting the feed mode switch to Manual/Single mode disables
[Check Overlapping (Ultrasonic)] in the multifeed detection
setting.
When you scan an A1 size document folded in half, support the
document from below with your hand so that it does not tilt.
HINT
The scanner will wait for the next document to be loaded until the
time specified for the Timeout time elapses, even if there is no
document in the ADF paper chute (feeder).
ATTENTION
For details about the paper weights of the documents that can be
scanned, refer to