Fujitsu Ricoh Fujitsu fi-7700 Document Scanner - Manual (Page 119)

Chapter 6 Replacing the Consumables
Appendix
Glossary
Introduction
Index
Contents
TOP
119
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Scanner
Overview
Replacing the
Consumables
Replace the pick roller in following procedure.
1
Turn off the scanner and wait for at least 15 minutes.
For details, refer to "1.3 Turning the Power ON/OFF" (page 23) .
2
Unplug the power cable.
3
Remove all documents from the ADF paper chute
(feeder).
4
Open the ADF.
For details, refer to "1.4 Opening/Closing the ADF" (page 24) .
5
Open the sheet guide.
Slide the side guides all the way by pressing the side guide buttons,
and pull the sheet guide open from the dip.
6.3 Replacing the Pick Roller
ATTENTION
There are two types of pick rollers. When replacing pick rollers, make
sure you replace both types at the same time.
When the ADF is open, it might close
accidentally. Be careful not to get your
fingers caught.
Dip
Sheet Guide
Side Guides
Side Guide Buttons