Fujitsu Ricoh Fujitsu fi-7700 Document Scanner - Manual (Page 177)

Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
177
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Checking and Resetting the Sheet Counters
■ Checking the Sheet Counters
The status of each consumable part can be viewed to
determine when to replace or clean the consumables.
The color of the counter gradually changes when a
replacement for a consumable is needed or when cleaning is
needed. The color of each counter changes as follows:
 Brake roller counter/pick roller counter
These counters turn light yellow when the sheet count after the
consumable replacement reaches 95% of the value specified in
"Replacement Cycle of Consumables [Life Counter Alarm Setting]"
(page 180)
in the Software Operation Panel, and turn yellow when the
sheet count reaches 100%.
 Counter after cleaning
This counter turns yellow when the sheet count after cleaning
reaches the value specified in
"Scanner Cleaning Cycle [Cleaning
Cycle]" (page 180) in the Software Operation Panel.
 Ink counter
This counter turns yellow when the amount of remaining ink reaches
below 33% (only displayed when the imprinter is installed).
1
Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 160) .
2
From the listing on the left, select [Device Setting].
In this window, you can check the following items:
8.4 Settings Related to Sheet Counters
Item Description
Total Count (ADF) Total number of sheets scanned using
the ADF
Total Count (FB)
[fi-7700/fi-7700S] Total number of sheets scanned using
the flatbed [fi-7700/fi-7700S]:
After cleaning Total number of sheets scanned after
cleaning
Brake Roller Number of sheets scanned after the
brake roller is replaced