beautypg.com

Appendix glossary introduction index contents top – Fujitsu Ricoh Fujitsu fi-7700 Document Scanner User Manual

Page 172

background image

Chapter 8 Operational Settings

Appendix

Glossary

Introduction

Index

Contents

TOP

172

How to Load
Documents

How to Use the
Operator Panel

Various Ways to
Scan

Daily Care

Troubleshooting

Replacing the
Consumables

Scanner
Overview

Operational
Settings

Document check area
specification for Multifeed
Detection

(page 201)

Selected range: Select this item to restrict the
area to run multifeed detection.

[Selected range] check box

Not selected

Enable/Disable (Middle): Specify whether to
enable or disable multifeed detection in the
selected area.

Enable/Disable
(When [Selected range] is selected)

Disable

Start (Middle): Specify the start position of the
area in length (mm) from the leading edge of
the document.

0 to 510 mm (in increments of 2)

0 mm

End (Middle): Specify the end position of the
area in length (mm) from the leading edge of
the document.

0 to 510 mm (in increments of 2)

0 mm

Intelligent Multifeed Function

(page 204)

When there is a paper of the same size
attached to a designated location on the page,
you can configure the scanner to memorize the
location of the attachment and not detect
multifeeds for that location.
Note that you first need to select [Check
Overlapping (Ultrasonic)] or [Check
Overlapping and Length] in either the scanner
driver or the multifeed detection setting in

"Specifying a Multifeed Detection Method
[Multifeed]" (page 199)

.

This setting can also be configured with the
operator panel.

Manual mode/Auto mode 1/Auto mode 2

Manual mode

Select to clear the overlap pattern (length,
location) memorized in Auto mode.
This setting can also be configured with the
operator panel.

[Clear overlap pattern] check box

Not selected

Select to enable the function for memorizing an
overlap pattern when overlapped documents
are detected in Auto mode.

[Memorize the overlap pattern automatically]
check box

Not selected

Specify whether or not to memorize the overlap
pattern upon power-off.

Remember/Do not remember

Do not remember

Item

Description

Parameter/Value

Factory Default