Item configurable in function selection, Item, Appendix glossary introduction index contents top – Fujitsu Ricoh Fujitsu fi-7700 Document Scanner User Manual
Page 82
Chapter 3 How to Use the Operator Panel
82
Item Configurable in Function Selection
*1: Although there is no factory default setting, it is set to [No.00] when you turn on the power. The settings do not change even when you initialize the
operator panel because there is no factory default setting.
Item
Description
Setting
Factory
Default
Function
Selection
Configure the application you want to launch when you press the
[Scan/Enter] button while the [Ready] screen is displayed.
It displays a scanner button event configured in the computer
([Scan Button]/[Send to 01] to [Send to 50]).
For "No.00", the [Scan Button] event is displayed.
For "No.01" to "No.50", an event from [Send to 01] to [Send to 50]
is displayed.
For information on how to configure scanner button events, refer
to
"Using a Button on the Scanner to Start Scanning" (page 92)
No.00 to No.50/SOP
(SOP indicates the Software Operation
Panel)
(*1)