Fujitsu Ricoh Fujitsu fi-7700 Document Scanner - Manual (Page 85)

Chapter 4 Various Ways to Scan
Appendix
Glossary
Introduction
Index
Contents
TOP
85
How to Load
Documents
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Various Ways to
Scan
How to Use the
Operator Panel
Scanning Documents with Different Widths
1
Align the top of the documents.
 Aligning at the center
 Aligning on one side
2
Place the documents at the center of the ADF paper chute
(feeder), and adjust the side guides to the widest
document in the batch.
For details, refer to "Chapter 2 How to Load Documents" (page 39) .
4.2 Scanning Documents of Different Types and Sizes
ATTENTION
When you scan a mixed batch with different widths, some of the
narrower documents may be skewed or not fed into the scanner. In that
case, you should place the narrower documents at the center of the
ADF so that the documents are fed into the scanner by feed rollers
without any problems.
HINT
For details about document requirements for scanning a mixed batch of
documents, refer to
"Conditions for Mixed Batch Scanning" (page 53) .
ATTENTION
Make sure that all documents are placed underneath the pick
roller. Otherwise, some documents may be skewed or not fed into
the ADF.
Width of the Pick
Roller
Good
Bad
Width of the Pick
Roller