Fujitsu Ricoh Fujitsu fi-7700 Document Scanner - Manual (Page 153)

Appendix
Chapter 7 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
153
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Troubleshooting
A shadow appears at the top or the bottom of the
scanned image.
Have you adjusted the offset (position to start the scan)?
No
In [Device Setting] of the Software Operation Panel, adjust the offset in the sub-
scanning direction.
For details, refer to
"Adjusting the Position to Start the Scan [Offset Setting/Vertical
magnification Adjustment]" (page 182) .
Yes
Did you use the Page Edge Filler function to fill out the
shadow around the edge?
No
In the scanner driver or in [Device Setting 2] of the Software Operation Panel, use
the Page Edge Filler function to fill out the shadow around the edge.
For details, refer to
"Removing Shadows/Streaks that Appear around the Scanned
Image [Page Edge Filler (ADF)]/[Page Edge Filler (FB)] (fi-7700/fi-7700S)" (page
184)
.
Yes
If the problem persists, check the items in "7.4 Before You Contact the Scanner
Service Provider" (page 156) first, then contact the distributor/dealer where you
purchased this product.